
Mount a Pole on Your Roof
Pole mounting brackets are an essential part of any roofing system. They provide a way to secure the roofing membrane around the perimeter of the roof, which protects the edge from wind uplift and other weather damage. Most pole mounts are installed after the roof has been completed and the membrane has been applied. For this reason, it’s important to use high-quality brackets that have been tested and approved for use with your particular roofing system.
Are you a roofing contractor who is looking for the best way to mount your pole on the roof. Click Here. If so, then you’ve come to the right place. we’ll show you how to mount your pole on the roof in a safe and effective way.
- First, find the perfect spot on your roof for the pole. You’ll want to make sure that the pole is mounted in an easily accessible spot that is also out of the way of traffic areas. Once you’ve found the perfect spot, mark it with a pencil so that you know where to drill the holes.
- Next, use a power drill to drill two holes into the marked spot. Be sure to use appropriate-sized drill bits so that the holes are big enough for the screws but not too big.
- Finally, insert the screws into the holes and tighten them until the pole is secure. That’s it! You’ve now successfully mounted a pole on your roof. Be sure to check it periodically to make sure that it is still secure.
There are 2 Types Of Pole Mount
There are two basic types of pole mounts: internal and external. Internal mounts are installed inside the building, while external mounts are installed on the exterior of the building. Each type has its own advantages and disadvantages, so it’s important to choose the type that will work best for your particular application.
- External mounts are typically easier to install, but they can be more vulnerable to weather damage.
- Internal mounts are more difficult to install, but they’re better protected from the elements.
Tools and Materials Needed For Roof Mount
- Drill with ½” spade bit or larger
- Jigsaw with fine-toothed blade (optional)
- Level (optional)
- Grainger 2CNF5 or similar telescoping fiberglass pole with base plate
- Lag screws (1/4″ x 2″ hex head) – 4 per base plate plus at least 2 extras
- Washers (1/4″) – 4 per base plate plus at least 2 extras