Metal Roofingin El Paso, TX
(915) 353-3934Phones answered 24/7
Lifetime Roofing of El Paso installs standing seam and exposed-fastener metal roofs on homes and buildings with our own crew, not subcontractors. Every installation carries a lifetime transferable workmanship warranty, printed beside the panel maker’s warranty.
- Phones answered 24/7
- Free inspection
- Free written estimate within 48 hours
- Lifetime transferable workmanship warranty
Leaky screws?Thin metal?No call back?
Metal panels show up across El Paso on warehouses and metal buildings, and we put metal roofs on homes too. Either way, the worries are the same: screws that leak, thin metal behind a low bid, and a roofing contractor who stops calling back.
Reviews of El Paso roofing contractors repeat the complaints about calls that never came back and leaks that returned. Lifetime Roofing of El Paso makes a promise on each of these worries.
“Never returned calls”
Our phones are answered 24/7, and you get a call if the crew runs late.
“leaking again by June”
If a leak comes back on our work, we come back and fix it at no charge.
“Vented Ridge Cap blew off in a wind!”
Our own crew installs the panels and trim, not subcontractors.
A low bid that turns out to be thin metal
You get a written estimate within 48 hours of the inspection, ready to hold up against any other bid.
Being sold a replacement you don’t need
We quote a repair when a repair will do.
An open roof, or nails left in the yard
We tarp any open roof each night and run a magnet sweep for nails.
Lines in quotation marks come from customers’ online reviews of El Paso roofers. Tell us about your metal roof project
What customers askabout metal roofs
How much does a metal roof cost in El Paso?
It depends on the roof. Lifetime Roofing of El Paso prices each metal roof after a free inspection. Panel type, gauge, finish, roof size, pitch and complexity, and tear-off set the price.
What is the biggest problem with metal roofs?
Exposed screws. Exposed-fastener roofs run about 70 screws per square (100 square feet), and each one is a possible leak point. Lifetime Roofing of El Paso also installs standing seam, which has no exposed fasteners.
Is a metal roof loud in the rain?
Not over a solid deck. Metal over a solid deck with underlayment runs about as quiet as shingles. The loud reputation comes from barns with open framing. Lifetime Roofing of El Paso installs underlayment with the panels.
What is the best metal roof color for El Paso heat?
A lighter painted finish. Darker colors gain more heat, and bare Galvalume reflects well but gives heat back poorly. PVDF paint holds color longest, while SMP paint fades sooner. Finish helps set the price on a Lifetime Roofing of El Paso estimate.
One roofing contractor,one contact, start to cleanup
Daniel Smith, ManagerDaniel Smith, our manager, is your one contact from the first call through cleanup. Lifetime Roofing of El Paso is a family-owned roofing company with more than a decade of experience, and we’ve been in El Paso since 2019. Our own crew does the work, with no subcontractors on your roof. Our prices sit in the fair middle of the El Paso market.
How a metal roof project goes,call to cleanup
- 1
Call, and a person answers
Dial (915) 353-3934 at any hour. You don’t need an insurance claim to get a free inspection.
- 2
Free inspection, repair or replacement
We inspect the roof you have now. If it only needs a repair, that’s what we’ll quote.
- 3
Free written estimate within 48 hours
The price for your metal roof reaches you on paper within 48 hours of the inspection. Financing is available.
- 4
Tear-off, underlayment, panels, and trim
Our own crew does all four, and any open roof gets tarped each night.
- 5
Magnet sweep and warranty paper
We sweep for nails with a magnet and hand you the warranty paper at the end of the job.
Standing seam orexposed fastener system
Lifetime Roofing of El Paso installs both, and the difference comes down to how the panel is held to your roof. Stone-coated steel is a separate roof system, DECRA by IKO Metals.
Standing seam
- Concealed clips or flanges sit under raised seams, so no screw passes through the weather face.
- The panel floats as the steel heats and cools.
- It’s the usual choice on a roof below 3:12 slope, which is 3 inches of rise per foot.
Exposed fastener
- Screws go through the panel face, and a washer seals each screw.
- Common profiles are corrugated, PBR, and R-panel.
- Sun hardens, cracks, and shrinks those washers.
A much lower bid may mean thinner gauge, wider screw spacing, or skipped underlayment. Any metal roof quote should state the gauge, profile, fastener or clip type, underlayment, and deck, so you can judge its value against another bid.
What El Paso, TXweather does to metal
Heat
Steel moves about 1/4 inch on a 30-foot panel per 100-degree change. Exposed fastening doesn’t allow for that movement, so screw holes wear.
Wind
Blow-off on a metal roof starts at the eaves and ridges. Repeated pressure works fasteners or clips loose.
Monsoon
Monsoon rain can get in at a worn screw hole or a cracked washer, so the panel type you pick matters here.
Hail
Hail can dent panels. NRCA calls dents generally cosmetic, while tearing, opened seams, or lost coating are functional damage.
Weather figures from the National Weather Service in El Paso. Panel movement figure from PAC-CLAD.
What you getin writing
A metal roof comes with two papers: the written estimate before we start and the warranty paper at the end. Workmanship means how the roof was installed, so that call comes to us, not to the panel maker.
The workmanship warranty transfers to the next owner if you sell.
Your metal roof
| Inspection | Free, insurance claim or not |
|---|---|
| Estimate | Free and written, within 48 hours of the inspection |
| Workmanship warranty | Lifetime and transferable, on the installation |
| Maker’s warranty | Printed beside ours, from the panel maker |
| If a leak comes back on our work | We come back and fix it at no charge |
| When you get the warranty paper | Handed over at the end of the job |
Tarping and inspections carry no warranty.
More questions aboutmetal roofing
How long does a metal roof last?
It depends on the panel. Trade estimates run 40 to 70 years for standing seam in Galvalume with PVDF, and 20 to 35 years before exposed-fastener roofs need re-screwing or restoration. None of that is El Paso data. Lifetime Roofing of El Paso’s warranty is on the installation.
Which is thicker, 24 gauge or 26 gauge metal roofing?
24 gauge. A lower number means thicker steel: 24 gauge is about 0.023 inch and 26 gauge about 0.018 inch. Gauge helps set the price of a metal roof from Lifetime Roofing of El Paso.
Why does my neighbor’s metal roof look wavy?
That’s oil canning. Oil canning is visible waviness in flat metal pans. It’s cosmetic, and it shows more in dark and glossy finishes. Lifetime Roofing of El Paso prices finish and panel type in your written estimate.
Do you tear off the old roof?
Yes. Tear-off is part of a metal roof from Lifetime Roofing of El Paso, along with underlayment, panels, and trim, all done by our own crew.
Does homeowners insurance go down with a metal roof?
Ask your insurer. Discounts vary by insurer and location, and many policies pair Class 4 impact discounts with cosmetic-damage exclusions on metal. Lifetime Roofing of El Paso’s Insurance Claim Documentation means documenting the damage and writing the estimate.
Can I pay for a metal roof over time?
Ask about financing. Financing is available from Lifetime Roofing of El Paso, and we offer a 5% military discount. Ask about both when you call (915) 353-3934.
Our metal roofingservice area
Lifetime Roofing of El Paso installs metal roofs across El Paso, Texas, from the East Side and West Side to Central, the Northeast, the Lower Valley, the Upper Valley, and Kern Place. We also work in Anthony, Canutillo, Clint, Fabens, Horizon City, San Elizario, Socorro, Vinton, and on homes off post at Fort Bliss.
Call Lifetime Roofing of El Paso about a metal roof project
(915) 353-3934
Get a free metal roof inspection
Based at 8914 Gateway Blvd E, El Paso, TX 79907